Secure SES 302 “Temperature”

The module

The jeedom visual

Summary

The SES302 probe allows the measurement of the indoor ambient temperature. It is powered by 2 AA batteries and is Z-Wave Plus certified. In addition to its main function, it is possible to wire various external SECURE probes on the module, either:

• An external NTC temperature sensor (SES001)
• 4 wired temperature sensors for hose or tank (SES002) connected by 1m cables
• 1 wired temperature sensor for hose or tank (SES003) connected by a 4m cable

These modules are perfect for temperature measurement in central heating control applications or any similar application. Its user interface is simple, with a local push button and an indication LED on the rear side. You can easily include / exclude it in a Z-Wave network.

Fonctions

• Accurate temperature measurement
• Application in dynamic control systems of tanks / tubes / heated floors /…
• Possibility to connect external sensors
• Interoperable with Z-Wave certified products and systems
• Quick and easy installation
• Low battery report

Technical characteristics

• Type: Portable / wall mount
• Temperature measurement range: ± 0.5 ° C for 0 ° C to 40 ° C
• Z-Wave Plus chip
• Frequency : 868.42 Mhz
• Alimentation: 2x AA batteries (LR6)
• Scope : up to 100 m in free field
• Protection sign : IP30
• Dimensions : 86 x 85 x 30 mm

Module data

• Mark : Horstmann
• Name : SES 302 Temperature Sensor
• Manufacturer ID : 89
• Product Type : 13
• Product ID : 2

Configuration

To configure the OpenZwave plugin and know how to put Jeedom in inclusion, refer to this Documentation.

IMPORTANT

To put this module in inclusion mode, press the button on the back for 1 second and release, according to its paper documentation.

Once included you should get this :

Commandes

Once the module is recognized, the commands associated with the module will be available.

Here is the list of commands :

• Temperature : it is the temperature measurement command
• Drums : it’s the battery command

Several non visible temperatures are also available and will be useful if you have connected external probes

Configuration of the module

IMPORTANT

During a first inclusion always wake up the module just after the inclusion.

Then it is necessary to configure the module according to your installation. To do this, go through the “Configuration” button of Jeedom’s OpenZwave plugin.

You will arrive on this page (after clicking on the parameters tab)

Parameter details :

• 1: Allows you to set how much the temperature must vary for the module to send it to Jeedom (in steps of 0.1)
• 2: Set the time interval for sending the temperature to Jeedom (in minutes)

All the other parameters are identical and correspond to all the external probes possibly connected

Groupes

This module has only one association group, it is essential

Wakeup

To wake up this module, press the button on the back once

Important note

IMPORTANT

You have to wake up the module : after its inclusion, after a change in configuration, after a change in wake up, after a change in association groups