Changelog Alarm

Important

As a reminder if there is no information on the update, it means that it only concerns the updating of documentation, translation or text

#

• Change tag #trigger# by #alarm_trigger#

Important

Please note that you must update your scenarios and the actions in your alarms. This change is due to a conflict between the scenario tags and the alarm tags which had the same name and therefore were overwritten

03/01/2024

• Preparing for jeedom 4.4
• Fixed a problem with the “separate zones” option when changing mode
• Interface improvement

22/01/2020

• Improved logs in case of multiple alarms

21/10/2019

• Fixed a bug during the creation of the equipment

10/14/2019

• Fixed a bug when renaming a mode

28/04/2019

• Bugfix

23/04/2019

• Bugfix

01/17/2019

• Possibility of using variables or calculation for the Hold (s), Activation and Trigger times
• Updating the doc

18/07/2018

• Updating the doc
• Bug fix on renaming modes
• If the alarm is already active the arming does not reactivate it
• Addition of an option for a multi-zone trip (if another zone goes into alert then the alarm is triggered)
• Addition of action when resuming monitoring of a sensor
• Adding the tag #zone#
• Ad a button to duplicate an alarm

06/03/2018

• Addition of orphan order management
• If sensors are disabled then ok activation actions are no longer triggered
• Bugfix
• Detectors with activation delays and being always active after this delay no longer trigger the alarm, but launch a KO activation, with monitoring of this excluded detector until a return to normal

02/12/2018

• Fixed a bug on moving actions in trigger

• Possibility of adding a hold delay for a trigger before triggering the alarm

12/01/2017

• Correction of a bug on deactivation of detectors

• Management of seconds on the activation delay (JEED-63)

• Backtracking on the non-initiation of immediate actions if the activation delay is empty or zero

• If during activation a sensor is on alert and has no delay of activation then the alarm is armed nevertheless by ignoring this sensor (unless he comes back to rest)

• Addition of global trigger action (no longer filtered by zone, it is recommended to use this rather than the actions of zone trigger)

• Code optimization

• Be careful : the alarm no longer performs immediate actions if there is no trigger delay !!!!!! ⇒ Canceled

• Ability to filter the actions in relation to alarm mode

• Add pause / resume command

• Improvement of the configuration interface