Everspring Miniplug Dimmer - AD147-6

The module

The Jeedom visual

Summary

The Mini Dimmer Plug is designed to control the switching on and off of lights and electrical equipment in your home. It also allows a dimmer function which is compatible only with bulbs. With a voltage of 220 - 240 V, this Dimmer Plug can support a load of 6 W to 250 W.

The Mini Dimmer Plug is a Z-Wave ™ compatible device that is intended to work with all Z-Wave ™ compatible networks. It can be controlled by a remote control, PC software, or any Z-Wave controller on your network.

Fonctions

• Control a lamp remotely
• Plug module integrating directly between an electrical outlet and the load to be controlled
• ON / OFF and Dimmer function to control lamps
• Local charge control via integrated button
• Z-Wave Plus technology
• Reduced dimensions to go almost unnoticed
• Status LED on the integrated button
• Z-Wave repeater function

Technical characteristics

• Type of module : Z-Wave receiver
• Food : 230 V, 50 Hz
• Consumption : 0.6W
• Maximum power : Resistive load : 250W, Incandescent bulb : 250W, Led bulb (not dimmable) : 6W
• Frequency : 868.42 Mhz
• Scope : up to 70 m outdoors, up to 30 m in buildings
• Affichage: LED on the button
• Dimensions : Length (plug included) : 74mm Diameter : 52mm

Module data

• Mark : Everspring
• Name : Miniplug Dimmer
• Manufacturer ID : 96
• Product Type : 3
• Product ID : 3

Configuration

To configure the OpenZwave plugin and know how to put Jeedom in inclusion, refer to this Documentation.

IMPORTANT

To put this module in inclusion mode, press its button 3 times, in accordance with its paper documentation. It is important to note that this module goes directly into inclusion when it does not belong to any network and it is powered

Once included you should get this :

Commandes

Once the module is recognized, the commands associated with the module will be available.

Here is the list of commands :

• Intensity : It is the command allowing to regulate the intensity of the catch
• We : This is the command that turns on the outlet
• Off : It is the command which makes it possible to extinguish the catch
• State : It is the command which allows to know the status of the socket

Note that on the dashboard, the State, ON / OFF, Intensity information is found on the same icon.

Configuration of the module

You can configure the module according to your installation. To do this, go through the “Configuration” button of Jeedom’s OpenZwave plugin.

You will arrive on this page (after clicking on the Settings tab)

Parameter details :

• 1 : This parameter defines the status value command, it is not advisable to change this value.
• 2 : This parameter defines the delay for sending the change of state to group 1 (value between 3 and 25 seconds)
• 3 : This parameter is used to define whether the socket will resume its status (ON or OFF) after a power recovery.
• 4 : This parameter allows you to define whether the outlet will operate in dimming mode or on / off mode

Groupes

This module has 2 association groups.

IMPORTANT

At least Jeedom should end up in group 1

Good to know

Specificities

• Status feedback cannot be configured within 3 seconds.

Wakeup

No notion of wakeup on this module.