Philio PST02 C - 3 in 1 Opening

The module

module

The Jeedom visual

vuedefaut1

Summary

The ZIP-PSM01 detector offers 3 different functions : opening detection, temperature sensor and light detector. It consists of two parts : a detector and a magnet. They are designed to be placed on a door or window with the magnet fixed on the opening part and the detector on the fixed part.

Opening the door or window will move the magnet away from the detector, which will trigger the detector which will send a Z-Wave alarm signal, if the system is armed (this signal can be operated by a siren or by a home automation box for example). The sensor can also be used for automatic lighting control, depending on the brightness level. For example, the sensor will send a signal to the Z-Wave switch to turn on the light when the door opens and the room is dark.

The detector will also raise the brightness and the temperature, i.e. in the event of a significant change, and each time the opening / closing is detected.

A Z-Wave controller (remote control, dongle…) is necessary in order to integrate this detector into your network if you already have an existing network.

Fonctions

Technical characteristics

Module data

Configuration

To configure the OpenZwave plugin and know how to put Jeedom in inclusion, refer to this Documentation.

IMPORTANT

To put this module in inclusion mode, press the inclusion button 3 times, according to its paper documentation.

inclusion

Once included you should get this :

Plugin Zwave

Commandes

Once the module is recognized, the commands associated with the module will be available.

Commands

Here is the list of commands :

Configuration of the module

IMPORTANT

During a first inclusion always wake up the module just after the inclusion.

Then if you want to configure the module according to your installation, you have to go through the “Configuration” button of Jeedom’s OpenZwave plugin.

Setup plugin Zwave

You will arrive on this page (after clicking on the parameters tab)

Config1

Config2

Config3

Parameter details :

Groupes

This module has two association groups, only the first is essential.

Groupe

Wakeup

To wake up this module there is only one way :

Important note

IMPORTANT

You have to wake up the module : after its inclusion, after a change in configuration, after a change in wakeup, after a change in association groups

Nous utilisons des cookies pour vous garantir la meilleure expérience sur notre site web. Si vous continuez à utiliser ce site, nous supposerons que vous en êtes satisfait.