The module
The Jeedom visual
This Wall Dimmer Micromodule from SmartHome Europe by Everspring, is designed to control the switching on and off of lights and electrical equipment in your home. It can also provide a dimmer function which is only compatible with bulbs. At a voltage of 230V, this module can support up to 300 Watts in resistive or incandescent charge, or 200 Watts in fluorescent charge.
It can be used in 2-wire mode (without neutral), replacing an existing switch, or three-wire with a conventional supply to the module (Phase + Neutral).
The Wall Dimmer Module is a Z-Wave ™ compatible device which is intended to work with all Z-Wave ™ compatible networks. It can be controlled by a remote control, PC software, or any Z-Wave controller on your network.
To configure the OpenZwave plugin and know how to put Jeedom in inclusion, refer to this Documentation.
IMPORTANT
To put this module in inclusion mode, press its button 3 times, in accordance with its paper documentation. It is important to note that this module goes directly into inclusion when it does not belong to any network and it is powered
Once included you should get this :
Once the module is recognized, the commands associated with the module will be available.
Here is the list of commands :
Note that on the dashboard, the State, ON / OFF, intensity information is found on the same icon.
You can configure the module according to your installation. To do this, go through the “Configuration” button of Jeedom’s OpenZwave plugin.
You will arrive on this page (after clicking on the parameters tab)
Parameter details :
This module has 2 association groups.
IMPORTANT
At least Jeedom should end up in group 1
No notion of wake up on this module.